STEP 1:
Clean the glass substrate with glass cleaner and ensure it is completely free
from any dirt, oil or grease.
![pcap film installation clean glass pcap film installation clean glass](https://www.twowaymirrors.com/wp-content/uploads/2020/10/pcap-film-installation-clean-glass.jpg)
STEP 2:
Remove the release liner from the permanent adhesive or temporary static
cling surface by carefully pulling it back at 180°. Temporarily taping down
the flexible cable support strip can make this easier. For the temporary static
cling version, roll up the liner and store for later reuse.
![pcap film installation release liner pcap film installation release liner](https://www.twowaymirrors.com/wp-content/uploads/2020/10/pcap-film-installation-release-liner.jpg)
STEP 3:
Spray the permanent adhesive or temporary static cling surface with soap
solution, ensuring that there are no dry spots.
![pcap film installation spray film pcap film installation spray film](https://www.twowaymirrors.com/wp-content/uploads/2020/10/pcap-film-installation-spray-film.jpg)
STEP 4:
Spray the glass substrate with soap solution, ensuring that there are no dry
spots in the area where the sensor will be applied.
![pcap film installation spray glass pcap film installation spray glass](https://www.twowaymirrors.com/wp-content/uploads/2020/10/pcap-film-installation-spray-glass.jpg)
STEP 5:
Apply the sensor to the glass substrate and slide into position.